Publicité
Preparing your harness
Installation of the reserve parachute
6 Capture the container flaps zippers.
Step 1
7 Using a plastic rod, pass the orange loops through the blue
loops and the metal eyelets.
8 Lock the container using the reserve
handle clips.
The handle must be oriented towards
the front of the harness, and the rods
must "press" it against the harness.
Finish the installation by inserting the
handle lugs into their respective slots.
1
Step 3
(Step 1)
2
Step 2
(Step 2)
(Step 3)
3
2
9 CLose the container with ther zipper
(Step 4)
CAUTION: bring the sliders to the end of
the zipper, otherwise the release of the
risers cannot be guaranteed.
At the end of assembly, it is imperative to check scrupulously that
At the end of assembly, it is imperative to check scrupulously that
no assembly tools are left in place (rod, hanger). This would make
no assembly tools are left in place (rod, hanger). This would make
it impossible to extract the parachute if necessary.
it impossible to extract the parachute if necessary.
More detailed information is available at www.korteldesign.com
More detailed information is available at
53
KANIBAL RACE II & ST
Rescue handle
1
Handle lugs
2
Handle rods
3
Container flaps
4
www.korteldesign.com
Publicité
