Publicité
3.9. LEVEL THE APPLIANCE
1.
Carefully slide the appliance into place.
2.
Place a spirit level on top of the appliance to check that the
appliance is level.
3.
If the appliance is not level, adjust the adjusting feet to level
the appliance:
a.
Loosen the adjusting foot bolt with an M17 spanner.
b.
Turn the adjusting foot in or out.
c.
Tighten the bolt again.
The maximum height of the adjusting feet is 5 cm.
3.10. TO CALIBRATE THE APPLIANCE
1.
Check that the drum is empty.
2.
Insert the power cable into the earthed socket.
3.
Press and hold the Standby button until the control panel lights up.
4.
Press and hold the accelerated programme button and temperature button until t19 appears on the control panel.
5.
Press the start/pause button.
The appliance is calibrated. When the appliance is ready, **** will appear on the control panel.
3.11. REMOVE FACTORY RESIDUE
Before using the appliance, it is recommended to run the appliance empty once in order to remove possible manufacturing
residues or odours:
1.
Select the cotton programme with the selector dial.
2.
Repeatedly press the temperature button until 90°C appears on the control panel.
3
3.
Press the start/pause button to start the laundry programme.
4.
Check if there is any leakage at the drain hose.
NOTE
• Check for leaks during the first wash. If leakage occurs, check that the drain hose is connected correctly and completely. If
there is no leakage, the drain hose is connected correctly.
48
Publicité
