Publicité
3. INSTALLATION
Before installing the appliance, carefully review the safety information in Section 1.
3.1. REQUIREMENTS ON THE LOCATION OF INSTALLATION
WARNING!
• FIRE HAZARD DUE TO SHORT CIRCUIT. Before use, check that the voltage on the socket you want to use matches that on
the type plate of the appliance (220-240V ~ 50Hz). Only connect the appliance to an earthed power socket. Damage
caused by faulty voltage is not covered by the guarantee.
2 2
• FIRE HAZARD DUE TO SHORT CIRCUIT. Make sure you install the appliance in such a way that the power cable is
always accessible.
CAUTION!
1
• RISK OF INJURY FROM LIFTING HEAVY OBJECTS. Always move the appliance with two people. Use two hands when
moving, lifting or turning the appliance.
NOTICE!
• RISK OF DAMAGE TO THE APPLIANCE. Make sure that the power cable is not trapped under the appliance.
• RISK OF DAMAGE TO THE APPLIANCE. Never connect the supply hose to a hot water tap.
Place the appliance at a location that satisfies the following conditions:
• A flat, stable, heat-resistant and moisture-resistant surface.
• In the case of a wooden floor, make sure the floor is solid and stable. If necessary, reinforce the floor.
• Ambient temperature between 5 – 40 °C.
• At least 2 cm of space on all sides.
• Not in direct sunlight
• Well ventilated
• Not directly next to heat sources, such as heaters or stoves
• An earthed socket within 150 cm.
• A stop cock within 150 cm. This is a tap with a ¾" thread.
• A sink siphon or drain pipe within 150 cm. If a separate drain pipe is chosen, it must have a minimum internal diameter of 4
cm and be present at a maximum height of 100 cm.
Are one or more of the above connections missing? If so, call on a qualified technician to install the required connections before
installing the appliance.
3.2. REMOVE AND CHECK THE PACKAGING
WARNING!
RISK OF SUFFOCATION. Never let children play with the packaging material. Keep the packaging material out of reach of
children.
1.
Remove the packaging material from the device.
2.
Lift the appliance with two people and remove the packaging under the appliance.
3.
Check that the styrofoam triangle underneath the appliance has also been removed. If not, place the appliance gently on
its side and remove the styrofoam triangle.
4.
Remove the water supply hose from the drum.
5.
Check the contents of the packaging using the picture in section 3.3. Main parts.
If parts are missing or damaged, please contact the Customer Service of Wisberg: www.wisberghome.com.
44
Publicité
