Publicité
3.7. CONNECTING THE SUPPLY HOSE
1.
Place a bucket or washing-up bowl under the stop cock.
2.
Turn the stop cock to its open position and let the water run
until clear water comes out of the stop cock.
3.
Connect the supply hose to the stop cock.
4.
Connect the other side of the supply hose to the water inlet.
5.
Check that there is no kink in the supply hose.
6.
Slowly open the stop cock and check for leaks. If leakage
occurs, check that the supply hose is connected correctly and
completely. If there is no leak, the supply hose is connected
correctly.
7.
Fully open the stop cock.
1
NOTICE!
• RISK OF DAMAGE TO THE APPLIANCE. Never connect the supply hose to a hot water tap.
• RISK OF DAMAGE TO THE APPLIANCE. Do not use tools for securing the supply hose.
3.8. CONNECTING THE DISCHARGE HOSE
The drain hose can be connected in two ways:
-
on a siphon (see section 3 . 8 . 1 . )
-
on a drain pipe (see section 3 . 8 . 2 . )
46
Publicité
