Publicité
Troubleshooting
Problem
Motor not run-
ning or cuts out
during opera-
tion
Garden waste
is not drawn in
Shredding ma-
terial comes
out in chains
Replacement parts/accessories
If you have issues ordering, please use the contact form. If you have any other questions,
contact the service centre (see page 127).
Plunger ............................................................................................................. 91105553
Housing plate ................................................................................................... 91105554
Cutting roll ........................................................................................................ 91105555
Pressure plate ................................................................................................... 91105556
Axle ................................................................................................................... 91105557
Two wheels/covering caps/assembly material ................................................. 91105558
Possible cause
Overload protection
No mains power supply
Cylinder ( 28) running
in reverse
Shredding material is too
soft
Cylinder (
28) is jammed Free up the jam
Pressure plate (
incorrectly adjusted
Spare parts and accessories can be obtained at
www.service-deltafox.de
Remedy
To turn it back on, move the direction
switch (
Press the reset switch (
Switch the device back on.
Check the socket, cable, lead and
plug for damage, and if neces-
sary, have any damage repaired
by qualified repair personnel.
Change rotational direction using
the switch
Insert wood or shred dried branches
(See section on working methods)
24) is
Readjust the pressure plate
(See section on working methods)
1) to the "I" position.
A
2).
GB
31
Publicité
