Publicité
Attachment: Installation instructions for decorative cover plate
Outlet
Step 1: Wrap PVC protective tape around drainage pipe,copper pipe
and cable.Adjust the copper pipe tube to a suitable shape.
The above diagram may be difference from the actual product, please refer to the actual product.
Note:
7.7 INDOOR UNIT INSTALLATION
The tube may be connected in several directions as below shown Figures.
1. Connecting right back tube (similar to right lower tube) (optional, Refer to
Fig.6)
• Pull out the tubing from bottom of the chassis; and connect the drainpipe.
Strap the joint of tubing reliably.
• Lead the connecting wire to the indoor unit (Do not connect to the power).
• Strap together the tubes, discharge pipe and connecting wire with adhesive
tape. The discharge pipe is put at the below. Remove the board which is on
the chassis.
• Check if the connections are reliable.
• Mount the indoor unit on the two hooks at the upper part of installation board.
(Refer to Fig.8)
7. INSTALLATION
Cover plate
Step 2: Install the cover plate.
Step 3: Finish
57
Pipeline
Connecting
Drain pipe
wires
Fig.6
Publicité
