Hardware Installation; Configuration - Acksys RailTrack Série Guide D'installation Rapide

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.
Plug the antennas in
Plug the antennas of your choice (not included) to the N-type connectors.
WARNING: Leaving an antenna connector unplugged may disturb radio
link quality and data throughput, and as well as waterproofness.
2.
Connect the power supply
See the "specifications" section about the characteristics of the power supply.
The device has no ON/OFF switch. It turns-on automatically when power is
applied. Check the Power LED.
The Diag LED stays red for around 50 seconds, until the device is fully ready
to use. Then the Diag LED turns green.
3.
Connect the Ethernet cable
Plug the Ethernet cable to the device's LAN1 or LAN2 connector. Connect the
end of the RJ45 cable to your network and check that the LAN1 or LAN2 LED
turns ON at that point.
4.
Modifying the default IP address 192.168.1.253
From any PC of the network, run the Windows application WaveManager
available on our website.
Go directly to step 5 if the default IP address is compatible with your network.
Else, select the device and click on « Configure » button. You can configure
the IP address or activate the DHCP client.

HARDWARE INSTALLATION

CONFIGURATION

-2-

Publicité

Table des Matières
loading

Table des Matières