Hardware Installation - Acksys AirBox WIFI V2 Guide D'installation Rapide

1. Plug the antennas in
Connect the supplied antennas on the connectors according to the model you
See section WiFi Ant' antenna connectors to get relevant
have.
information.
2. Connect the power supply
See the Power
characteristics of the power supply.
The device has no ON/OFF switch. It turns-on automatically when power is
applied. Check LEDs PWR1 and PWR2:

PWR1 LED is ON if power supply 1 or PoE is ON.

PWR2 LED is ON if power supply 2 is ON.
The Diag LED stays red for around 60 seconds, until the device is fully ready
to use. Then the Diag LED turns green.
3. Connect the Ethernet cable

If you want to use the product in PoE mode, connect the PoE
source onto LAN2. Do not connect simultaneously PWR1/PWR2
power supplies.

Plug the provided Ethernet cable to the LAN1 or LAN2 connector.

Check that the corresponding LAN1 or LAN2 LED turns ON at
that point.

HARDWARE INSTALLATION

supply and CONNECTORS
- -
2
sections about the