Hardware Installation; Configuration - Acksys WLg-ABOARD V3 Guide D'installation Rapide

1. Plug antennas
Connect the two integrated antennas to "Main" & "Aux" N-type connectors.
WARNING : For single antenna application, please make sure to install a
50 Ohm terminator on the "Aux" antenna port. If not, WiFi interface may
be damaged !
2. Connect the power supply
See the "specifications" section about the characteristics of the power supply.
WLg-ABOARD/NI and WLg-ABOARD/NPI product use EARTHED power
supply: isolated 0V is connected to Earth Ground. Do not connect the
source input to Earth Ground, to preserve isolation with the power
supply.
POE models (WLg-ABOARD/NP & /NPI) can be powered by a POE power
source (48 VDC) connected to LAN2 connector. In this case, the power
supply connector (M12) should be left unplugged.
The device has no ON/OFF switch. It turns on automatically when power is
applied. Check leds Power1 and Power2 :
Power1 led is ON if POWER1 power supply or POE source is ON.
-
Power2 led is ON if POWER 2 power supply is ON.
-
The Diag led stays ON until the device is ready to use, usually in less than
10s.
3. Connect the Ethernet cable
Plug the Ethernet cable to the device's LAN1 or LAN2 M12 connector. The
RJ45 side can be connected to any RJ45 plug of the network, and then
verify that:
LAN1 or LAN2 led is ON (According to the Ethernet port which is
-
plugged in).
4. Modifying the default IP address 192.168.1.253
From any P.C of the network, run the multi-platform application ACKSYS
NDM application (found on the ACKSYS web site).
CAUTION : the field « Model » is filled with the generic name « WLg-
ABOARD/N_V3 » for products WLg-ABOARD/NI, WLg-ABOARD/NPI, WLg-
ABOARD/N_V3 et WLg-ABOARD/NP_V3.
Go directly to step 5 if the default IP address is compatible with your network.
Select the device and click on « Configure IP » button.
You can configure the IP address or activate DHCP.

HARDWARE INSTALLATION

Earth grounding precautions

CONFIGURATION

-2-