Hilti C 4/12-50 Mode D'emploi page 19

instructions and always refer to it when contacting your Hilti representative
or service center.
Type:
Generation: 01
Serial no.:
en
2 Description
2.1 Use of the product as directed
The appliance is designed to charge Hilti Li-ion batteries with a rated voltage
of 10.8 volts.
The working environment may be as follows: construction site, workshop,
renovation, conversion or new construction.
The appliance is not intended for wall mounting.
Good air circulation around the appliance must be ensured.
Tampering with or modification of the appliance is not permissible.
Observe the information printed in the operating instructions concerning
operation, care and maintenance.
Nationally applicable industrial safety regulations must be observed.
Observe the safety precautions and operating instructions for the accessor-
ies used.
To avoid hazards, use only batteries of the approved type.
The appliance is designed for professional use and may be operated,
serviced and maintained only by trained, authorized personnel.
personnel must be informed of any special hazards that may be encountered.
The appliance and its ancillary equipment may present hazards when used
incorrectly by untrained personnel or when used not as directed.
The appliance may be operated only when connected to an electric supply
providing a voltage and frequency in compliance with the information given
on its type identification plate.
Do not use the battery as a power source for other unspecified appliances.
2.2 Items supplied as standard
1 Charger
1 Operating instructions
16
Printed: 14.02.2014 | Doc-Nr: PUB / 5170386 / 000 / 00
All manuals and user guides at all-guides.com
This