Installation; Appropriate Installation Location - Grundig GTMU 14110 Manuel D'utilisation

3. Installation

Refer to the nearest Authorised
Service Agent for installation of
the product. To make the product
ready for use, make sure that
the electricity installation is
appropriate before calling the
Authorised Service Agent. If not,
call a qualified electrician to have
any necessary arrangements
carried out.
Preparation of the
C
location and electrical
installation at the place
of installation is under
customer's responsibility.
Product must not be
B
plugged in during
installation. Otherwise,
there is the risk of death
or serious injury!
WARNING:
and electrical
connections of the
product must be carried
B out by the Authorised
Service Agent.
Manufacturer shall
not be held liable for
damages that may arise
from procedures carried
out by unauthorised
persons.
WARNING:
installation, visually
A
check if the product has
any defects on it. If so,
do not have it installed.
Damaged products cause
risks for your safety.
10
C
3.1 Appropriate
A
•
Installation
•
•
Prior to
•
•
Make sure that the power
cable is not pinched or
crushed while pushing
the product into its place
after installation or
cleaning procedures.
installation location
WARNING:
of the room where the
product will be placed
is too small for the
product to pass, then the
product's doors must be
removed and the product
must be turned aside to
pass it through.
Choose a place at where
you would use the product
comfortably.
Install the product at least 30
cm away from heat sources
such as hobs, ovens, heater
cores and stoves and at least 5
cm away from electrical ovens.
Product must not be subjected
to direct sun light and kept in
humid places after installation.
Appropriate air ventilation must
be provided around your product
in order to achieve an efficient
operation. If the product is to be
placed in a recess in the wall,
pay attention to leave at least 5
cm distance with the ceiling and
side walls.
Do not place the product on
the materials such as rugs or
carpets.
Place the product on an even
floor surface to prevent jolts.
If the door