Publicité
SANDING
1
Align the holes in the sanding
paper 5
with the ones in the sanding plate 3.
Press the sanding paper into place.
Caution! Make sure the tool is
switched off and the battery re-
moved.
POLISHING
1
Put the polishing pad on the work-
bench with the white velcro fastener
up. Place the sanding plate centred
onto the polishing pad.
Caution! Make sure the tool is
switched off and the battery re-
moved.
CHANGE THE SANDING PLATE
1
Remove the four screws of the sanding
plate 3.
Caution! Make sure the tool is
switched off and the battery re-
moved.
ATTACH BATTERY
1
Slide the battery
7
(not included) onto
the tool until it snaps into place.
Caution! Only use the tool with the
batteries specified in technical
data.
SWITCH ON
1
Start the sander by pressing the on/ off
switch
2
at the position I.
Start the tool before sanding to pre-
vent damage to your workpiece.
130
EN
All manuals and user guides at all-guides.com
2
To remove the sanding paper
5
care-
fully peel it off the sanding plate 3.
Never use the sander without sand-
ing paper or polishing pad.
2
Apply a proper amount of polishing
agent to the clean polishing pad and
smoothen it with a putty knife or flat
object over the entire surface.
Note: Dirt and spots without polishing
agent may destroy the surface of the
workpiece.
2
Replace the sanding plate 3. Align the
holes in the new sanding plate with
the ones in the orbital sander and fix
the sanding plate by screwing the four
screws tight.
2
To release the battery 7, press the bat-
tery release switch
6
and slide off the
battery.
SWITCH OFF
2
Stop the sander by pressing the on/ off
switch
2
at the position 0.
Lift up the sander from the work-
piece before switching off the tool.
1
1
1
1
1
2
2
2
2
2.
1.
2
Publicité
