Publicité
3. Charging indicators (LED indication)
4. Menu navigation
5. OK / Select
6. Pause (stop / resume charging)
7. USB (for firmware updates only)
8. NFC symbol ( GET Ready)
Charging
WARNING
RISK OF ELECTRIC SHOCK!
Do not use the battery charger if it is damaged.
Disconnect the mains immediately.
Do not touch damaged parts, uninsulated battery
terminals, connectors, or other live electrical
parts.
Contact service personnel.
CAUTION
Incorrect connection of dual charging cables may
result in damage to the battery or the battery
charger. If using dual charging cables, connect
them to only one battery pack/application.
Connect and start charging
1. Check the cables and connectors for visible
damage.
2. Connect the mains cable. The mains indicator
lights up blue when the mains is connected.
3. Connect the battery charger to the battery. If
using dual charging cables, connect them to
only one battery pack/application. See Fig. 5
Connection of dual charging cables.
•
The BMS controls the charging process. If
charging curve is used, the charging
process starts automatically.
The charging status is shown on the
•
display on the control panel and by the
charging indicators (LED indication).
•
Green LEDs indicate that the battery is
fully charged. The battery charger
continues with maintenance charging.
•
The battery can be continuously connect-
ed to the battery charger when not in use.
For a detailed description, see the section LED
indication.
Stop charging and disconnect
CAUTION
RISK OF MATERIAL DAMAGE!
Do not disconnect the battery when the charging
process is in progress. Arc flash may occur and
damage the connector pins. Always stop the
charging process before the battery is
disconnected.
CAUTION
If using dual charging cables, always disconnect
both cables in sequence. Disconnecting only one
cable may result in improper operation of the
charger and a minor electric shock if the
connectors are touched.
1. Stop the battery charging process by pressing
the Pause button on the battery charger
control panel.
The charging process can be resumed by
pressing the Pause button again.
2. While stopped, disconnect the battery charger
from the battery. If using dual charging cables,
always disconnect both cables.
ENGLISH
7
Publicité
