Publicité
Setup
Menu
Setting
the
HDM[
audio
ff you are not using the HDH[
audio
output, you shouJd set this to [Off].
[f the monitor/receiver
connected
to this
player using HDH[
does not support
HDHU audio signat input, set this to [Off].
Un'AUDUO SETUP PAGE', press AT
to
highlight [HDHU AUDUO],
then press _,
Notes:
-
Super Audio CD signals cannot be output
using HDML
-
This player can output following audio
signals using HDMI: 32/44.1/48
kHz, 2oh
linear PC,Msignals and bitstream signals
(Dotby Digital, D TS and MPEG).
-
When audio signals are being output by
HDMl_compatibte
components, digital
output signals are muted.
ON
Select this to turn on the HDHI
audio
output.
OFF
Select this to turn off the HDHI
audio
output.
Speaker
Setup
This menu contains setup options
for
audio output
so that you can set your
speakers to reproduce
high quality
surround
sound. For details, see page 13.
This feature allows you to convert
your
music CD to a higher sampling rate using
sophisticated
digital signal processing for
better sound quality, If you have activated
the upsampting function,
the player will
automatically
switch to stereo mode.
1
In _AUDIO SETUP PAGE', press A_' to
highlight [CD UPSAHPLING],
then press
OFF
Select this to disable CD-upsampling.
Select this to convert the sampling rate of
CDs to twice that of the original
Select this to convert the sampJing rate of
CDs to four times that of the original
2, Press sky to select a setting, then press
ENTER/OK
to confirm your selection.
Note:
-
This setting is only valid for signals output
from the analogjacks.
Night
Node
In this mode, high volume
output
is
softened and low volume
output
brought
upward to an audible level It is useful for
watching
your favorite action movie
without
disturbing
others
at night.
1
In _AUDIO SETUP PAGE', press sk_' to
highlight [NIGHT
MODE], then press _,
o_
Select this to level out the volume.
This
feature is only available for movies with
Dolby Digital mode,
OFF
Select this when you want to en]oy the full
dynamic range of surround
sound.
2. Press AV to select a setting, then press
ENTER/OK
to confirm your selection.
29
Publicité
