Maintenance; Maintenance Schedule - Husqvarna 525HE3 Manuel D'utilisation

4. Fold the cutting unit to make it parallel to
the shaft.
Introduction
WARNING:
the safety chapter before you do
maintenance on the product.

Maintenance schedule

Maintenance

Clean the external surface.
Clean the muffler, exhaust pipe and engine from leaves, dirt and
unwanted lubricant.
Make sure that the cutting unit does not move at idle speed.
Do a check of the stop switch.
Examine the cutting unit for damages and cracks. Replace if it is
damaged.
Do a check of the throttle trigger lockout and the throttle trigger.
Examine the engine, the fuel tank and the fuel lines for leaks.
Tighten nuts and screws.
Examine the fuel filter for contamination and the fuel hose for
cracks and other defects. Replace if necessary.
Examine the starter and the starter rope for damages.
Clean the air filter. Replace if it is necessary.
Examine the vibration damping units for damages and cracks.
Examine the spark plug, refer to
1173 - 001 -
Maintenance
Read and understand
Technical data on page 21 .
Daily Weekly Monthly
After each operation.
After each operation.
X
X
X
X
X
X
X
X
X
X
X
15