Télécharger Imprimer la page

Publicité

Liens rapides

INSTALLATION INSTRUCTIONS
Over The Range Microwave Oven
BEFORE YOU BEGIN
IMPORTANT
Save these instructions for local
inspector's use.
IMPORTANT
Observe all governing codes and
coordinates.
NOTE TO INSTALLER
instructions with the Consumer.
NOTE TO CONSUMER
future reference.
SKILL LEVEL
– Installation of this appliance requires
basic mechanical and electrical skills.
1 MOUNTING SPACE
This Over the Range Microwave Oven requires a mounting
space on a wall as shown in Figure 1. It is designed to be used
with standard 12" wall cabinets. The maximum depth is 13".
13" max depth.
15.5"
Backsplash
At least 2"
As a guide to installation, see page 8 for Mounting
Template Information.
All manuals and user guides at all-guides.com
Read these instructions completely and carefully.
– Be sure to leave these
– Keep these instructions for
30"
30" or more
from cooking
surface
66" or more
from fl oor
Figure 1
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not covered
under the Warranty.
Please read all instructions thoroughly before installing
the Over the Range Microwave Oven. Two people are
recommended to install this product.
If a new electrical outlet is required, its installation should
be completed by a qualifi ed electrician before the Over the
Range Microwave Oven is installed. See 3 ELECTRICAL
GROUNDING INSTRUCTIONS on page 2.
2 WALL CONSTRUCTION
This Over the Range Microwave Oven should be mounted
against and supported by a fl at vertical wall. The wall must
be fl at for proper installation. If the wall is not fl at, use spacers
to fi ll in the gaps. Wall construction should be a minimum of
2" x 4" wood studding and
The mounting surfaces must be capable of supporting weight
of 110 pounds—the oven and contents—AND the weight of
all items which would normally be stored in the top cabinet
above the unit.
The unit should be attached to a minimum of one 2" x 4"
wall stud.
To fi nd the location of the studs, one of the following methods
may be used:
A. Use a stud finder, a magnetic device which locates the
nails in the stud.
B. Use a hammer to tap lightly across the mounting surface
to find a solid sound. This will indicate stud location.
The center of the stud can be located by probing the wall with
a small nail to fi nd the edges of the stud and then placing a
mark halfway between the edges. The center of any adjacent
studs will normally be 16" or 24" to either side of this mark.
NEED HELP?
For customers in the United States and Canada
United States: 1-800-944-9044
Canada: 1-800-265-8352
READ CAREFULLY. KEEP THESE INSTRUCTIONS.
3
/
" or more thick dry wall or plaster/lath.
8
316902446
April 2011
TINSEB294WRRZ-EL12
Printed in Thailand

Publicité

loading

Sommaire des Matières pour Electrolux EI30BM55HS

  • Page 1 All manuals and user guides at all-guides.com INSTALLATION INSTRUCTIONS Over The Range Microwave Oven BEFORE YOU BEGIN Read these instructions completely and carefully. IMPORTANT • Save these instructions for local • Proper installation is the responsibility of the installer. inspector’s use. •...
  • Page 2 NOTE: 2. Neither Electrolux nor the dealer can accept any liability for Furnace duct sealing tape is recommended to seal duct damage to the oven or personal injury resulting from failure connections to the Exhaust Dampener Assembly.
  • Page 3 • Scissors the cavity or on the door. If there is any damage, do not • Pencil operate the oven and contact your dealer or Electrolux • Measure AUTHORIZED SERVICER. • Tape 6 INSTALLATION HARDWARE ➀...
  • Page 4 All manuals and user guides at all-guides.com INSTALLATION INSTRUCTIONS (B) HORIZONTAL EXHAUST: 8 VENTILATION SYSTEM OUTSIDE VENTILATION (PREPARING OVEN FOR INSTALLATION) 1. Remove 3 screws from back edge and 5 screws from the top of Fan Cover Bracket. Save 3 screws to use them to This Over the Range Microwave Oven is designed for attach Exhaust Damper Assembly to the wall later and adaptation to three types of hood ventilation systems.
  • Page 5 All manuals and user guides at all-guides.com INSTALLATION INSTRUCTIONS (C) VERTICAL EXHAUST: OUTSIDE VENTILATION Rotate 180° Fan Blade Openings 1. Remove and save 3 screws from back edge and 5 screws from the top of the Fan Cover Bracket to use at Step 5. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket as shown in Figure 11.
  • Page 6 All manuals and user guides at all-guides.com INSTALLATION INSTRUCTIONS NOTE: THIS OVEN SHOULD BE ATTACHED TO AT LEAST ONE WALL STUD. Rotate 180° Fan Blade Openings MOUNTING PLATE 1. Separate Toggle Nuts, packed in the INSTALLATION HARDWARE, from 4 Toggle Bolts. IMPORTANT Use the mounting template provided to Use wood screws to attach mounting plate to the...
  • Page 7 All manuals and user guides at all-guides.com INSTALLATION INSTRUCTIONS MOUNTING OVEN TO THE WALL Tapping Screw (A) Two people are recommended to attach the Microwave Oven/ Hood to the Mounting Plate. 1. Thread the power supply cord through the hole made in the bottom of the top cabinet.
  • Page 8 All manuals and user guides at all-guides.com NOTES...
  • Page 9 All manuals and user guides at all-guides.com INSTRUCCIONES DE INSTALACIÓN Horno microondas sobre la estufa ANTES DE COMENZAR Lea estas instrucciones completa y detalladamente. IMPORTANTE • Guarde estas instrucciones para uso del • La correcta instalación es responsabilidad del instalador inspector local.
  • Page 10 1. Si tiene preguntas acerca de las instrucciones eléctricas o de conexión a tierra, consulte un electricista califi cado. NOTA: 2. Ni Electrolux ni el distribuidor pueden aceptar ninguna Se recomienda utilizar cinta selladora en los conductos del responsabilidad por daño al horno o por lesiones personales...
  • Page 11 • Lápiz opere el horno y comuníquese con su distribuidor o • Cinta para medir con el PROVEEDOR DE SERVICIOAUTORIZADO DE ELECTROLUX. 6 HERRAJES DE INSTALACIÓN ➀ ➅ Los elementos de la tornillería de instalación del están en una bolsa pequeña. Todos los elementos se encuentran en una caja de cartón debajo del horno.
  • Page 12 All manuals and user guides at all-guides.com INSTRUCCIONES DE INSTALACIÓN (B) ESCAPE HORIZONTAL: 8 SISTEMA DE VENTILACIÓN EXTRACCIÓN HACIA EL EXTERIOR (PREPARACIÓN DEL HORNO PARA SU INSTALACIÓN) 1. Retire 3 tornillos del borde posterior y 5 tornillos de la parte superior del soporte de la cubierta del ventilador. Guarde los 3 tornillos para utilizarlos más tarde para Este Horno microondas sobre la estufa está...
  • Page 13 All manuals and user guides at all-guides.com INSTRUCCIONES DE INSTALACIÓN (C) ESCAPE VERTICAL: EXTRACCIÓN HACIA EL EXTERIOR Gire 180˚ Orifi cios de las Paletas del Ventilador 1. Retire y guarde 3 tornillos del borde posterior y 5 tornillos de la parte superior del soporte de la cubierta del ventilador para utilizarlos en el Paso 5.
  • Page 14 All manuals and user guides at all-guides.com INSTRUCCIONES DE INSTALACIÓN NOTA: ESTE HORNO DEBE SUJETARSE A AL MENOS UNA Gire 180˚ Orifi cios de las Paletas COLUMNA DE PARED. del Ventilador PLACA DE MONTAJE 1. Extraiga las tuercas de anclaje, empaquetadas en los HERRAJES DE INSTALACIÓN, de los 4 pernos de anclaje.
  • Page 15 All manuals and user guides at all-guides.com INSTRUCCIONES DE INSTALACIÓN MONTAJE DEL HORNO EN LA PARED Tornillo Auto-perforante (A) Il recommandé d’utiliser deux personnes pour placer le four à micro-ondes et sa hotte sur la plaque de fi xation. 1. Passez le cordon secteur par le trou fait dans le fond du cofret supérieur.
  • Page 16 All manuals and user guides at all-guides.com NOTAS...
  • Page 17 All manuals and user guides at all-guides.com INSTALLATION D INSTRUCTION ‚ Four à micro-ondes monté au dessus d une cuisinière AVANT DE COMMENCER Lire attentivement la totalité de ces instructions. IMPORTANT • Conserver ces instructions pour l’inspecteur • L’installateur est responsable de sa bonne installation. local.
  • Page 18 électrique ou de la mise à la terre, consultez un électricien de moins de 140 pi. (42,7 m). de métier ou un réparateur qualifi é. 2. Ni Electrolux ni le revendeur ne peuvent accepter aucune REMARQUE: responsabilité des dégâts au four, ou des blessures Il est recommandé...
  • Page 19 Mètre porte. Si vous trouvez un quelconque dommage, ne faites • Bande autocollante pas fonctionner le four et contactez votre revendeur ou UN SERVICE AGRÉÉ DE DÉPANNAGE ELECTROLUX. 6 MATÉRIEL D’INSTALLATION ➀ ➅ Les articles de quincaillerie du matériel d’installation à...
  • Page 20 All manuals and user guides at all-guides.com INSTRUCTIONS D’INSTALLATION (B) ÉCHAPPEMENT HORIZONTAL: 8 SYSTÈME DE VENTILATION VENTILATION EXTÉRIEURE ‚ (PRÉPARATION DU FOUR POUR L INSTALLATION ) 1. Enlevez les 3 vis du bord arrière et les 5 vis au-dessus de la fixation du couvercle de ventilateur.
  • Page 21 All manuals and user guides at all-guides.com INSTRUCTIONS D’INSTALLATION (C) ÉCHAPPEMENT VERTICAL: VENTILATION EXTÉRIEURE Ouvertures pour Pales Tournez 180° du Ventilateur 1. Enlevez les 3 vis du bord arrière et les 5 vis au-dessus de la fixation du couvercle de ventilateur pour les utiliser à l’étape 5.
  • Page 22 All manuals and user guides at all-guides.com INSTRUCTIONS D’INSTALLATION REMARQUE: CE FOUR DOIT ÊTRE FIXÉ À AU MOINS UN POTEAU MURAL. Ouvertures pour Pales Tournez 180° du Ventilateur PLAQUE DE FIXATION 1. Séparez les 4 boulons à ailettes, emballés avec le MATÉRIEL d’INSTALLATION, des écrous à...
  • Page 23 All manuals and user guides at all-guides.com INSTRUCTIONS D’INSTALLATION MONTAGE MURAL DU FOUR Vis Autotaraudeuse (A) Il recommandé d’utiliser deux personnes pour placer le four à micro -ondes et sa hotte sur la plaque de fi xation. 1. Passez le cordon secteur par le trou fait dans le fond du cofret supérieur.
  • Page 24 All manuals and user guides at all-guides.com REMARQUES...