Publicité
Concrete floor applications
CAUTION
Always wear safety glasses and other necessary
protective devices or apparel when installing or working
with anchors — risk of injury!
Not recommended for use in light-weight masonry
material such as block or brick.
Not recommended for use in new concrete which has
not had time to cure.
Do not use core drills to drill holes for this anchor.
Use concrete anchor M8 and M8 screw. Additional use the
wooden screws provided, see overview diagram "Use the
screws in the screws set".
m = Drilla 137.51 OQ mm) diameter hole any depth exceeding
the minimum embedment. Use the provided drill.
m=
Clean hole or continue drilling additional depth.
6.
Attaching an alternative anti-tip
device
IMPORTANT NOTE
if the anti-tio brackets cannot be attached securely,
an alternative anti-tio device can be attached.
However, ensure that there is no play between the
appliance and the anti-tio device.
if possible, always screw the wooden beam to existing
studs on the rear panel of the cavity.
a.
b.
Cc.
m = Manually insert the screw into the wall plug until the
screw begins to resist.
m = Knock the wall plug and screw into the hole until the
screw head is approx. '/5" (13 mm) from the anti-tip
bracket.
im
Saw the wooden beam (cross section min. 3" x 4")
to the required length.
Length is equal to the width of the installation cavity!
—
If the installation cavity is deeper than the
appliance, select a beam which has a larger cross
section or attach 2 beams.
—
The beam must cover the appliance by
at least 2" (60.8 mm).
832332
(2126,1
+1/32
+imm
m
Mark the installation height (ower edge of the beam) on
the rear panel of the cavity.
15
Publicité
