Publicité
4.
Installation preparation
Unpack installation materials and accessories.
To improve allocation to the work steps, the packages are
identified differently.
To do this, comply with the overview sheet attached to the
appliance!
5.
Preparing the installation cavity
mearSee am)
WARNING
Assure that there are no electrical wires or plumbing in
m= — If the installation cavity is deeper than the appliance,
the area which the screws could penetrate.
place a solid wooden beam behind the anti-tio-brackets
Risk of injury and damage!
and attach securely to the base or the wall.
The length of the wooden beam is equal to the width of
the installation cavity!
NOTE
if possible, always screw the wooden beam to existing
—
2 anti-tio-brackets are required for each appliance.
studs on the rear panel of the cavity.
—
The distance between the anti-tio-brackets is
inati
adequately the width of the appliance.
Wood floor application
—
Insome installations the sub-flooring or finished floor
Use the wooden screws provided, see overview diagram
may necessitate angling the wood screws used to
"Use the screws in the screws set".
fasten the anti-tio-brackets to the back wall.
—
The supplied set contains fastening screws for
various applications. Select the fastening screws
according to the local conditions.
—
Ifthe supplied fastening screws do not permit
secure attachment of the anti-tio brackets and
therefore the appliance, another method must be
used to attach the anti-tio brackets securely.
m
Specify the attachment points of the anti-tio-brackets.
Specify the detailed dimensions according to the section
on "installation dimensions" starting on page 9.
m = Drill pilot holes:
'/." (8 mm) for the (5 x 60 mm) wooden screws
°/g4" (2 mm) for the (4 x 15 mm) wooden screws
Being certain the screws penetrate through the flooring
and into the wall plate a minimum of
S/4" (19 mm).
m=
Attach the anti-tip-bracket completely. Be sure screws
hold tight.
14
Publicité
