Bosch TASSIMO my way 2 TAS65 Serie Manuel D'utilisation page 30

en Technical specifications
T DISC has not been correctly inserted.
1. Insert the T DISC with the printed side
facing downwards.
Check whether the tab of the T DISC is
2.
in the recess.
Brewing unit cannot be opened.
Brewing unit is locked.
▶
Only open the brewing unit when the
status display remains lit continuously.
▶
If the brewing unit remains locked, con-
tact the TASSIMO careline.
Water is dripping from the brewing unit.
T DISC is damaged or not correctly
inserted.
▶
Use a new T DISC.
T DISC piercing unit is not correctly
inserted.
▶
Press the T DISC piercing unit into the
holder until it clicks audibly into place.
There is water under the cup stand.
Condensation has formed due to technical
reasons or valves are clogged with
limescale.
▶
Descale the appliance.
No LED is lit.
Appliance is in idle mode.
▶
Press or open or close the brewing
system.
, and are flashing.
There are problems with the power supply.
Pull out the mains plug, wait 5 minutes
1.
and plug it back in.
2. If the problem persists, contact the
TASSIMO careline.
lights up although there is enough
water in the water tank.
Float is stuck in the water tank.
Descale the appliance.
1.
Reach into the water tank and move the
2.
float up and down.
30
lights up although softened water
has been used.
Decalcified water still contains small
amounts of lime.
▶
Descale the appliance.
and are flashing, brewing is not
possible.
Appliance has a fault.
1. Unplug the mains plug.
2. Contact the TASSIMO careline.
Controls do not respond to touch.
Control panel is soiled.
Pull out the mains plug.
1.
Clean the controls with a soft, damp
2.
cloth.
Re-insert the mains plug in the socket.
3.
Quality of beverages has deteriorated,
e.g. crema or volume.
Beverage outlet is soiled.
▶
Clean the beverage outlet.
▶
Clean the brewing unit with the T DISC.
Build-up of limescale in the appliance.
▶
Descale the appliance.
Drink volume has reduced.
Drink dispensing halts.
Water tank has not been sufficiently filled.
Fill the water tank with fresh, cold water
1.
up to the mark
Keep pressed until the desired fill
2.
volume is reached.
Water filter change display no longer
working.
Battery is flat.
▶
Press and hold the Start button of the
display for at least 5 seconds.
▶
Contact the TASSIMO careline if the
problem persists.
specifications Technical
Technical specifications
specifications Technical
Voltage
⁠ .
220–240 V ∼