Publicité
INSTALLATION OF WALL ANCHORS OR SCREWS
1 Place the LaundryPure 2 0 to the wall and mark the appropriate
keyholes with a pencil
NOTE:
Washing machine and cold water faucet must
be within 4 feet (1 21 m) of the right side of unit
A If using supplied wall anchors, drill two 3/16" (4 76 mm) diameter
holes Place two wall anchors into the wall Install two supplied screws
and tighten until almost all the way in
B If mounting to wall studs, drill two 3/32" (2 381 mm) diameter holes
approximately 1" (25 4 mm) deep Install two supplied screws and
tighten until almost all the way in
NOTE:
The provided hardware kit contains adhesive backed rubber
spacers to be placed on back of unit to provide additional
clearance from wall if needed for hose installation or the use
of ActiveClean Port (Page 12)
2 Position the keyholes of the LaundryPure 2 0 onto the screws
(not shown) Finish tightening screws enough to securely
mount unit, but still allowing it to be removed from wall
Remove unit from wall
6
Screws (not shown)
17 3" (43 94 cm)
Keyholes
Publicité
