Publicité
INSTALLATION REQUIREMENTS
ELECTRICAL REQUIREMENTS
100 - 240 Volt 50/60 Hz 5 AMP (minimum) Fuse or Circuit Breaker
LaundryPure 2 0 is equipped with an AC to DC power supply
CAUTION:
NEVER USE AN EXTENSION CORD.
WATER REQUIREMENTS
A dynamic water pressure greater than 20 psi / 1 37 bar and less than 60
psi / 4 13 bar is required to correctly operate your LaundryPure 2 0
See Cautions below
CAUTION:
Incoming water pressure must be greater than 20 psi / 1 37 bar If
your household water pressure is greater than 60 psi / 4 13 bar, you
must install an in-line pressure reducer before installing LaundryPure
2 0 Failure to follow these instructions may result in water leakage,
property damage, personal injury, and may void your warranty
Water pressure of 20 psi / 1 37 bar to 60 psi / 4 13 bar is required to
correctly operate your LaundryPure 2 0 Low water pressure may
prevent your unit from operating properly and/or cause a failure in
your washing machine's water valve
5 19" (13 48 cm)
4
17 3" (43 94 cm)
3 69" (9 37 cvm)
LOCATION CONSIDERATIONS
The LaundryPure 2 0 must never be installed in areas where water
may freeze since the unit will always maintain some water in the unit,
the water valve, and hose areas This can cause damage to internal
components It is also recommended to avoid installation in areas of
high humidity, as it can effect the operation of the unit
The washer's water valve may also not shut off completely Check
the documentation supplied with your washing machine for exact
specifications Your washing machine and cold water faucet must be
within 4 feet of the right side of the unit to use the inlet hose provided
with your LaundryPure 2 0
TO AVOID THE POSSIBILITY OF WATER DAMAGE, SHOULD A
HOSE LEAK, ALWAYS HAVE FAUCETS ACCESSIBLE AND TURN
OFF FAUCETS WHEN WASHER IS NOT IN USE. DO NOT USE WITH
A CARBON FILTER.
WATER
INLET
WATER
OUTLET
Publicité
