Publicité
4.3 Set Date/Time
Open the MENU interface, navigate to"System Setup"►"Time &
Date", and press the OK button to set the date/time. Navigate UP
or DOWN to select date and time values. Press OK to confirm and
proceed. To finish setup, just press the MENU button to exit.
NOTE:
Date format is YY/MM/DD with the time in 24 hour format.
4.4 Loop Recording
After inserting a memory card, the camera
will (by default) immediately start loop
recording video when connected to a
power source and powered ON. If the
device is not connected to a power
source, it will not immediately start on and
record.
While recording, the LED indicatorwill blink
and a red dot will flash on the top left of
the screen. You can stop/start the record-
ing at any time by pressing the UP button.
By default, the Loop Recording Time is 3
minutes. Please go to "Record
Setup"►"Loop Recording" to change it
to 1 minute or 5 minutes.
The loop recording video file name format
is "Year_Date Time_ SerialA.
MP4 ". For example:"2019_0301_060101_001A.MP4". the suffix A
indicates front cam recorded files, while the suffix B refers to rear
Time&Date
2019 / 04 / 11
17 : 16 : 39
YY / MM / DD
- 13 -
OnDash S1
3
1920x1080P 30FPS
HDR
00:00:16
000MPH
2019/04/10
14:42:25
EV
0.0
Publicité
