Télécharger Imprimer la page

Technics SU-GX70 Manuel D'utilisation Fonctions De Base page 15

Amplificateur réseau audio
Masquer les pouces Voir aussi pour SU-GX70:

Publicité

3 Connect the AC power supply cord to
this unit. ( 13)
4 Press [ ] to turn this unit on.
• When the connection is established,
"
" is displayed.
5 Press [>INPUT<] to select "Google
Cast".
6 Open the "Technics Audio Center"
app and follow the on-screen
instructions to set up a connection.
Note
• While the AC power supply cord is
disconnected, the LAN cable must be
connected or disconnected.
• Use category 7 or above straight LAN cables
(STP) when connecting to peripheral devices.
• Inserting any cable other than a LAN cable in
the LAN port can damage the unit.
• When a LAN cable is connected, the Wi-Fi
function may be disabled.
Wireless LAN connection
Preparation
Disconnect the AC power supply cord.
Disconnect the LAN cable.
Place this unit as close to the wireless router
as possible.
Point up the antenna on the rear of this unit
as shown in the figure.
Connect the AC power supply cord to this
unit. ( 13)
Note
• The setting will be cancelled after the set time
limit. In that case, try the setting again.
• To cancel this setting in the middle, press [
or turn the unit to standby mode.
• When the connection is established, "
displayed.
Wireless setup for the first time
using app
1 Press [
• "Wi-Fi Setup" is displayed.
2 Press [ ], [ ] to select "Yes" and
then press [OK].
• "Setting" is displayed.
3 Open the "Technics Audio Center"
app.
4 Select "Click here for
wireless setup for
your new main unit".
5 Select this unit and
follow the on-screen
instructions to set
the network.
Note
• This unit will be displayed as "Technics-SU-
GX70-
****
("
set.)
• You can check your network information
(SSID, MAC address and IP address) from the
"Technics Audio Center" app.
]
• When this unit is switched to standby mode
and turned on before the Wi-Fi setting is
" is
complete, "Wi-Fi Setup" is displayed. Complete
the Wi-Fi setting or set "Wi-Fi Menu" to "Off"
to turn off the display.
] to turn this unit on.
****
" if the device name is not set.
" stands for characters unique to each
Basic
15
(15)

Publicité

loading