Publicité
Assure that the front wheel is free from any load when dismounting top yoke!
Remount top yoke together with both Tour Match clamps as one unit. To fix top yoke, first tighten
steering head nut up to 15Nm / 11lbf ft, then fix the slider tube clamp bolts. Now tighten steering
head nut up to the required torque, tightening torques refer to the vehicle manufacturer's
instruction. Push Match clamps up towards the top yoke until there is an 8mm gap, align
them and tighten them slightly. Now install the tubes using M6x22 and tighten these bolts with
10Nm (7.31lbf ft). Do not use any grease / oil at the the bolts!
Now you should check the clearance to the tank and faring, therefore you have to mount all
controls provisorily on the clip-on. Adjust clip ons by turning the Match clamps on the slider tubes,
then tighten the bolts M6x25 with 10Nm (7.31lbf ft). Now drill the bores for the controls and fix
them finally. The left grip should be installed with glue.
Fit the left reservoir into the tube, as shown. Tighten the reservoir bracket with the outside bolt
until it sticks firm in the tube. Don't try to tighten the bracket with too much torque until the
bolt is blocked, the clamping rubber would be destroyed!
———————————————————
Rev. 01 31/03/2021
All manuals and user guides at all-guides.com
Zubehör von
—
Das Original
Seite 5 von 9
——
Publicité
