Publicité
This fine pump that you have just purchased is designed from the latest in
material and workmanship.
Before installation and operation, we recommend the following procedures:
Check with your local electrical and plumbing codes to ensure you
A
comply with the regulations. These codes have been designed
with your safety in mind. Be sure you comply with them.
We recommend that a separate circuit have to be lead from
B
the home electrical distribution panel properly protected with
a fuse or a circuit breaker. We also recommend that a ground
fault circuit 'GFCI' be used. Consult a licensed electrician for all
wiring.
The ground terminal on the three prong plugs should never be
C
removed. They are supplied and designed for your protection.
Never make adjustments to any electrical appliance or product
D
with the power connected. Do not only unscrew the fuse or trip
the breaker, remove the power plug from the receptacle.
Material required for sewage pump application
Desired length of ABS/DWV 2'' pipe, to link up from pump discharge to waste or drain
existing pipe.
Required quantities of 2'' ABS/DWV elbow(s) and/or other fitting(s) to run the discharge line.
1 only 2'' ABS/DWV male adaptor to 2'' slip, to connect the discharge pipe to the pump.
Desired length of ABS/DWV 3'' pipe and required quantities of 3'' ABS/DWV elbow(s) and/or
other fitting(s) to run the vent line.
1 only 2'' union check valve #450457.
1 only 18'' X 30'' minimum size sewage basin like #400420.
Teflon tape and ABS cement.
Tools
Screwdrivers, hacksaw to cut pipe, knife to assist in pipe cutting, round file to smooth pipe
ends, pipe wrench adjustable wrench, 1/4'' drill bit and drill. Ensure that you have a gas tight
cover for your sewage basin and 3'' ABS/DWV vent piping.
2
FOR INFORMATION | TEL : 514.337.4415 | FAX : 514.337.4029
SAFETY INSTRUCTIONS
NOTICE
This unit is not designed for applications to
pump salt water or brine.
Use with salt water or brine will void warranty.
Publicité
