Publicité
To clean the cabinet
Use a soft and dry cloth.
To clean the tape heads
When the tape heads are dirty;
- high frequency sound is not emitted
- the sound is not adequately high
- the sound is off-balance
- the tape cannot be erased
- the tape cannot be recorded on
To demagnetize the tape heads
Care of discs
* When a disc becomes dirty, wipe the disc from the center out
with a cleaning cloth.
Care of tapes
* Store tapes in their cases after use.
To reset
carry out step 2.
17 ENGLISH
GENERAL
There is no sound.
* ls the AC cord connected properly?
* Is there a bad connection? (> page 3)
* There may be a short circuit in the speaker terminals.
— Disconnect
the AC cord, then correct the speaker
connections.
¢ Was an incorrect function button pressed?
Sound is emitted from one speaker only.
* Is the other speaker disconnected?
An erroneous display or a malfunction occurs.
~ Reset the unit as stated below.
The unit blacks out when the power is off.
* Is the unit set to power economizing mode? (> page 5)
The power is not turned on.
* Disconnect the AC cord, and connect it again in a few seconds.
TUNER SECTION
There is constant, wave-like static.
* Is the antenna connected properly? (— page 3)
* Is the signal weak?
— Connect an outdoor antenna.
The reception contains noise interferences or the sound
is distorted.
* Is the system picking up external noise or multipath distortion?
— Change the orientation of the antenna.
— Move the unit away from other electrical appliances.
CASSETTE DECK SECTION
The tape does not run.
* Is deck in pause mode? (— page 10)
* Is the playback head dirty? (+ page 17)
Recording is not possible.
« Is the recording head dirty? (+ page 17)
Erasure is not possible.
+ Is the erasure head dirty? (> page 17)
* Is a metal tape being used?
CD PLAYER SECTION
The CD player does not play.
* Is the disc correctly placed? (— page 8)
* Is the disc dirty? (+ page 17)
¢ Is the lens affected by condensation?
— Wait approximately one hour and try again.
Publicité
