Publicité
SETTING THE CLOCK
VOL/
MULTI JOG
a
2
DEMO/ECO
To set the clock during power off, press Ill until the clock
is displayed.
2 Within 4 seconds, press << or ®
to designate
the time, then press II.
Each time <4
or ®
is pressed, the time changes by 1
minute. To change the time by 30 minutes, press and hold
<<< or PP.
* VOL/MULTI JOG is also available instead of << and >>.
To display the current time
With power on, press DISPLAY once on the remote control. The
time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
When the power is off, press DEMO/ECO
repeatedly until the
display changes to clock.
To switch to the 24-hour standard
With power on, press DISPLAY once on the remote control then
press i within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
SETTING THE SLEEP TIMER
fe)
&
7
VOL/
MULTI JOG
«
he
=
-
2
I
1
<<
°
al
ro)
The unit can be turned off automatically at a specified time.
7 Press SLEEP.
SLEEP
2 Within 3 seconds, press << or >
to specify
the time until the power is turned off.
The time changes between 5 and 240 minutes in 5-minute
steps.
* VOL/MULTI JOG is also available instead of << and >>.
9a
Specified time
To check the time remaining until the power is turned off
Press SLEEP
once. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press SLEEP twice so that "SLEEPoFF" appears on the display.
ENGLISH 14
Publicité
