Gladiator Garageworks GARF19XXPK02 Instructions D'installation page 3

Lower Front Corner
A
B
A. Leveling bolt (do not remove)
B. Refrigerator/freezer unit bolt
10. Place the slot in the rear of the caster bracket over the unit hole
in the rear of the refrigerator/freezer. Align the front hole of the
caster bracket with the unit hole in the front of the
refrigerator/freezer.
Lower Rear Corner
12. Insert two of the 1/4-20 x 1 W' hex-head bolts and lock washers
into the two caster bracket holes in the side as shown. Push the
caster bracket against the bottom of the refrigerator/freezer and
tighten the bolts using a %" socket wrench.
A
A. Caster bracket holes
13. Repeat steps 10 - 12 for the other caster bracket.
I I l*+dl l,>jl I 1%J411 J, I
1. Lock the front casters.
NOTE: Locking the casters will help prevent the refrigerator/
freezer from moving while it is being lifted.
2. Insert a small piece of cardboard between the caster brake and
the floor. This will help prevent the brake from rubbing on the
floor.
A
B
A. Refrigerator/freezer rear unit hole
B. Caster bracket
11. Hold the bracket in place and insert the unit bolts into the front
and rear unit holes and tighten.
NOTE: Do not overtighten the bolts.
3. Stand the refrigerator/freezer upright.
4. Replace the base grille by placing the metal clips in the openings
in the metal panel and rolling the grille downward until it snaps
into place.
5. Unlock the casters and move the refrigerator/freezer into its final
location.
6. Lock the casters.