Gladiator Garageworks GARF19XXPK02 Instructions D'installation page 2

INSTALLATION INSTRUCTIONS
Gather the required tools and parts before starting installation.
Tools Needed:
• 1/2"Socket wrench or nut • 3/8"Socket wrench or nut
driver driver
• 1/2"Wrench
Parts Supplied:
• Rigid casters (2)
• Swivel casters (2)
• _A6-18 Self-locking
hex-nuts (16)
• _6-18X%"
Hex-head bolts (16)
• 1A-20 X 1 1/4" Hex-head
bolts (4)
• 1/4-20 x 1 1/4" Lock
washers (4)
• Caster brackets (located in
FeaturePak) (2)
• Plastic skids (shipped with
the refrigerator/freezer)
Depending on your model, the casters may be packed in either the
upper or lower compartment. Remove the box containing the
casters.
Excessive Weight Hazard
Use two or more people to move and install
refrigerator/freezer.
Failure to do so can result in back or other injury.
NOTE: Install the casters before you install any of the FeaturePak
items.
1. Open the lower compartment door and remove the base grille.
Remove the grille by grasping the grille with both hands, lifting up
and pulling bottom of the grille toward you.
2. Place the plastic skids (shipped with the refrigerator/freezer) on
the floor at least 3 ft (91.44 cm) apart. Lay a piece of cardboard
or other protective material over the skids. This will elevate the
refrigerator/freezer to allow for easier caster installation and also
protect it from scratches.
NOTE: If the skids have been discarded or are not available,
2" x 4" boards may be used.
3.
Place the refrigerator/freezer on its side on top of the cardboard
or protective material. Make sure the door hinge is facing
upward.
IMPORTANT: It is important that the door hinge face upward
during the entire caster installation.
B
A. Top Hinge
B. Center Hinge
4. Remove the casters and fasteners from the box.
5. Locate and remove the caster brackets from the FeaturePak.
6. Using _/16-18 hex-head bolts, attach one rigid caster and one
swivel caster to each caster bracket. The rigid caster fits the front
of the bracket, and the swivel caster fits on the rear.
7. Insert the hex-head bolts from the bottom and start the self-
locking nuts for each caster.
J_
A
B
I
C
D
A. Self-locking nut
B. Caster bracket
C. _8-18 x _" Hex-head bolt
D. Caster
8. Hold the head of the hex-head bolt with a wrench while
tightening the self-locking nuts with a socket wrench.
9. Using a 1/2" socket wrench, remove the four unit bolts (two on
each side) from the lower front and rear of the refrigerator/freezer.
NOTE: Do not remove the leveling bolt.
2