Publicité
The display shown opposite appears after the balancing process.
The braking process can now be initiated.
Remove the calibration weight (200 g) from the inside of the wheel
rim and move to the outside.
The third pass can then be started by turning the wheel.
Manual turning can be stopped as soon as the display shows "run".
The machine will then measure the wheel imbalance.
The display shown opposite appears after the balancing process and
shows the correct calibration.
The braking process can now be initiated.
2.10 Completion of Work
Before commissioning, check all fastening screws, electrical, pneumatic and hydraulic
lines and, if necessary, tighten these. Warning: in some cases, this must be checked at
regular intervals and tightened if necessary (note in the instructions).
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
All manuals and user guides at all-guides.com
Manufacturer ATH-Heinl GmbH & CO.KG
- 23 -
Publicité
