OHAUS Defender 3000 Serie Manuel D'instructions page 7

Defender 3000 Series Floor Scale
Defender 3000 SERIES FLOOR PLATFORM, INSTALLATION OF OPTIONAL FOOT PLATES AND
RAMPS
Plates are required for certifiable installations. Installation of each Ramp also requires the installation of one set of Foot Plates.
Foot Plates are available separately and are included with the Ramp accessory kit. Refer to Figure 3 for mounting of the Foot
Plates and Ramps. Installation of Floor Plates and Ramps must be done before final placement of the Floor Scale.
LEGEND: 1.Foot Plate, 2. Bolt, 3. Spring Washer, 4. Washer, 5. Expanding Bolt, 6. washer, 7. Nut
Notes:
1. Expanding bolts require 12.5mm diameter holes drilled 60mm deep into the floor surface.
2. Foot Plate center to center dimensions W and L are shown in Table 4.
3. The Floor Scale must be positioned so that the load cell feet rest within the large holes of the Foot Plates.
4. Ensure that a free air gap exists between the sides of the Floor Scale and the edges of the Ramps.
MODELS
Ramp for i-DF2500B1R/C1R
Ramp for i-DF25 00B1L/C1L,
i-DF5000B1L/C1L
Ramp for i-DF2 500B1X/C1X,
i-DF5000B1X/C1X
1.800.561.8187
Figure 3. Optional Foot Plate and Ramp Installation
TABLE 6. DIMENSIONS FOR FLOOR PLATE AND RAMP INSTALLATION
RAMP
A
3 / 914 mm
4 / 1220 mm
5 / 1524 mm
www.
DIMENSIONS (mm)
B W
26.4 / 670 mm / 805 mm
26.4 / 670 mm 43.7 / 1110 mm
26.4 / 670 mm 55.7 / 1414 mm
information@itm.com
.com
EN-5
FOOT PLATE CENTERS
L
/ 805 mm
43.7 / 1110 mm
55.7 / 1414 mm