Publicité
EN
OPERATION
MAINTENANCE
1. Exhaust vent
2. Inhalation vent
ACCESSORIES
ENVIRONMENTAL DISPOSAL
In order to avoid damages on transportation, the tool has to be delivered in solid packaging. Packaging as well as the unit and accessories are made of
recyclable materials and can be disposed accordingly. The tool's plastics components are marked according to their material, which makes it possible to remove
environmental friendly and differentiated because of available collection facilities.
Only for EU countries
Do not dispose of electric tools together with household waste material!
In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in accordance with
national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible
recycling facility.
7
Polishing operation
WARNING:
• To reduce the risk of electric shock, check the tool's water supply system to ensure there is no damage to the seals
("O" rings) or hoses. A damaged water supply system may result in abnormal water flow to the tool which could be
dangerous.
CAUTION:
• Always wear safety goggles or a face shield during operation.
• Never switch on the tool when it is in contact with the workpiece, it may cause an injury to operator.
• Never run the tool without the abrasive disc. You may seriously damage the pad.
Make sure that the cock is closed. Connect the hose to the tool. Make sure that water comes out when the water lever is opened.
Hold the tool firmly. Turn the tool on and then apply the abrasive disc to the workpiece.
Apply slight pressure only. Excessive pressure will result in poor performance and premature wear to abrasive disc.
CAUTION:
• Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
The tool and its air vents have to be kept clean. Regularly clean the tool's air vents or whenever the vents start to become
obstructed.
Replacing dust cover brush
Replace the brush on the dust cover shortly after its tip is damaged. To replace the brush, slide it in the direction of arrow
as shown in the figure.
The dust cover is used to reduce the risk of dust intrusion into tool body. Be sure to use the tool with the dust cover in
place when operating. Should it be damaged, replace it with new one without fail.
Long use and operation of the tool using much water causes buildup of dust inside the tool. To maintain the product
safety and operate the tool with high efficiency, always check the exhaust vent at the back of tool.
When you find buildup of dust in that area, ask the Service Center for cleaning inside of the tool. Never disassemble or
clean the inside of the tool by yourself. Early request for cleaning is recommended at all times.
To maintain product safety and reliability, repairs, carbon brush inspection and replacement, any other maintenance or
adjustment should be performed by an authorized Service Center, always using the genuine replacement parts.
CAUTION:
• These accessories or attachments are recommended for use with the tool specified in this manual. The use of any
other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its
stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Service Center.
• Abrasive discs
• Side grip
• Front grip
• Rubber pad
WWW.NIKOLAOUTOOLS.COM
Publicité
