Publicité
EN
1. Head cover
2. Screw
1. Gear housing
2. Stopper
3. Front grip
4. Flat washer
5. Hex socket head bolt
1. Abrasive disc
2. Pad
3. Spindle
1. Water cock
2. Hose connector
3. Connector
4. Hose
6
Installing or removing the front grip
CAUTION:
• Make sure that the front grip is installed securely before operation.
• The front grip and the side grip cannot be installed at the same time.
Remove two screws and then the head cover. (The front grip cannot be installed during the installation of head cover
on the tool.)
Install the front grip on the tool so that its stopper fits to the gear housing and tighten the two screws as shown in the
figure. (The front grip and the side grip cannot be installed at the same time.)
Installing or removing abrasive disc (Optional accessory)
Remove all dirt or foreign matter from the pad.
Screw the pad onto the spindle with pressing the shaft lock.
Attach the disc to the pad so carefully that the edges of disc and pad overlap each other without protruding.
To remove the abrasive disc, pull off its edge from the pad.
Hose connector assembly
Use the hose connector assembly to connect to water source. It consists of the following parts.
Part name
Hose Connector
Connector
Hose
5/8'' in inner diameter × 25'' in length
Assemble the above parts hand tight as follows.
1. Attach the hose connector to the outlet of water cock.
2. Tighten the connector firmly to the hose. Insert the connector to the hose connector as far as it will go.
3. Tighten the hose connector to the end of the hose.
4. Fit the hose connector to the port on the tool.
WWW.NIKOLAOUTOOLS.COM
Description
1,2'' pipe thread
1,2'' mail pipe thread
Publicité
