Publicité
INSTAI [ATION
INSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Removing
packaging
materials
•
Remove tape and glue residue from surfaces before turning
on the refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
•
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see the "Refrigerator
Safety" section.
When Moving Your Refrigerator:
Your refrigerator
is heavy. When moving the refrigerator
for cleaning or service, be sure to protect the floor.
Always pull the refrigerator straight out when moving it.
Do not wiggle or "walk" the refrigerator when trying to move
it, as floor damage could occur.
Cleaning before use
After you remove all of the packaging materials, clean the inside
of your refrigerator before using it. See the cleaning instructions
in the "Refrigerator Care" section.
Important
information
to know about glass shelves
and
COVerS:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature
changes or impact, such as bumping.
For your protection,
tempered glass is designed to shatter
into many small, pebble-size
pieces. This is normal. Glass
shelves and covers are heavy. Use special care when re-
moving them to avoid impact from dropping.
Explosion
Hazard
Keep flammable
materials
and vapors, such as
gasoline,
away from refrigerator.
Failure to do so can result in death, explosion,
or fire.
NOTE: Do not install the refrigerator near an oven, radiator, or
other heat source, nor in a location where the temperature will fall
below 55°F (13°C).
2
3
l
13114"
(34 cm)
=
1
II
36
n
--
(91.5 cm) -_,
72
n
(182.9
cm)
161/2"
(42 cm)
D
2 ww
(5.1 cm)
12_/2 '' _,
20114"
_-_2crn)-
I
"
(51.5crn)_.,,{
_---2"
I
(51cm)
21/2'' J
--
91/4"
(6.4 cm)
(23.5 cm)
1. Minimum
fixed
wall position.
2. For full-overlay
cabinet
doors
and a trim kit, the
height
of the opening
must
be
72 _ in. (183.2
cm).
3. Recommended
locations
for electrical
and water
connections.
........
1
•
If you are installing the refrigerator to fit flush with the front of
the base cabinets, all shoe molding and baseboards must be
removed from the rear of the refrigerator opening.
•
The water hookup and electrical hookup must be placed near
the bottom of the refrigerator.
•
A trim kit is available for those installations where the
refrigerator will not fit flush. See the "Assistance
or Service"
section for ordering information.
4
Publicité
