Electrolux EIS62341 Notice D'utilisation page 19

Problem
Heating up takes a long time.
and appear simultane‐
ously.
and appear simultane‐
ously.
and appear simultane‐
ously.
You hear a beep sound, the indi‐
cators above blink and
SenseBoil® does not start.
and a number come on.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes
Possible cause
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
Cookware is too small and receives
only a part of the power generated
by the cooking zone.
The power is too low due to unsuita‐
ble cookware or an empty pot.
The pot is empty or contains some
liquid other than water, e.g. oil.
There is too much or too little water
in the pot.
You boiled some food other than wa‐
ter and potatoes. The boiling point
was moved in time and SenseBoil®
could not work properly.
None of the cooking zones is ready
to be used with SenseBoil®. There
is some residual heat on the cooking
zones you want to choose or they
are still in use.
There is an error in the hob.
on. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The
instructions about the Service Centre and
conditions of guarantee are in the guarantee
booklet.
Remedy
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
For optimal heat transfer use cook‐
ware with bottom diameter similar to
the size of the cooking zone (i.e. the
maximum cookware diameter value in
"Technical data" > "Cooking zones
specification").
Use the appropriate type of cookware.
Refer to "Hints and Tips" and "Techni‐
cal Data".
Do not activate any zone with an emp‐
ty pot on it.
Avoid using the function with liquids
other than water.
Only boil water and potatoes with the
use of SenseBoil®. Refer to "Hints and
Tips".
Finish your previous cooking activities
and choose a free cooking zone with‐
out any residual heat.
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
ENGLISH
comes
19