If all cooking zones are already in use or
there is some residual heat on all of
them, the hob emits a beep sound, the
indicators above
function does not start.
To deactivate the function touch
function deactivates and the heat setting
goes down to 0) or touch the control bar and
adjust the heat setting manually.
5.5 Using the cooking zones
Place the cookware in the centre of the
selected zone. Induction cooking zones adapt
to the dimension of the bottom of the
cookware automatically.
For optimal heat transfer use cookware
with bottom diameter similar to the size of
the cooking zone (i.e. the maximum
cookware diameter value in "Technical
data" > "Cooking zones specification").
Make sure that the cookware is suitable
for induction hobs. For more information
on cookware types refer to "Hints and
tips".
You can cook with large cookware placed on
two cooking zones at the same time. The
cookware must cover the centres of both
zones but not go beyond the area marking. If
the cookware is located between the two
centres, Bridge function will not be activated.
blink and the
(the
5.6 Bridge
The function operates when the pot
covers the centres of the two zones. It
does not work with the SenseBoil®
function.
This function connects two left side cooking
zones and they operate as one.
First set the heat setting for one of the left
side cooking zones.
To activate the function: touch
change the heat setting touch one of the
control sensors.
To deactivate the function: touch
cooking zones operate independently.
5.7 Automatic Heat Up
Activate this function to get a desired heat
setting in a shorter time. When it is on, the
zone operates on the highest setting in the
beginning and then continues to cook at the
desired heating setting.
To activate the function the cooking zone
must be cold.
To activate the function for a cooking
zone: touch
(
touch a desired heat setting. After 3 seconds
comes on.
To deactivate the function: change the heat
setting.
. To set or
. The
comes on). Immediately
ENGLISH
11