Publicité
tool is restarted on the workpiece, the grinding
wheel may jam, creep out or rebound.
5. Supporting the plate or oversized workpieces can
minimize the risk of grinding wheel seizure and
rebound. Large workpieces droops with their own
weight. Supports must be placed near the cutting
4 Installation and function description
Installation instructions
Guard installation and adjustment
line of the workpiece and near the edge of the
workpiece on both sides of the grinding wheel.
6. Please take extra care when "blind cutting" into
walls or other blind areas. The extended grinding
wheel may cut the gas pipe or water pipe, electric
wire or object causing rebound.
1. Guard
2. Screw
The guard is a kind of protective device, which is used
to prevent injury due to broken grinding wheel during
operation. When installing the guard, turn the angle
grinder upside down, take out the slot of the front cover
(3) of the guard (1) and put it into the guard (1). Adjust the
direction of the grinding wheel guard (1) in the direction
of the arrow as required by the working conditions, and
then fully tighten the screws (2) with a cross screwdriver.
Before starting work, please confirm that the guard is
installed and fastened. Slightly loosen the set screw,
the guard can be rotated and fixed at the required
working angle, and confirm whether the set screw is fully
tightened after the guard is adjusted.
3. Front cover
EN
7
Publicité
