Publicité
● Do not install the battery until the accessory and
water supply is connected to the product.
● Stop the product and remove the battery in the event
of malfunction or damage during use. Refer to "7
Troubleshooting" on page 9.
4.3 To connect the product to a
water supply
4.3.1 To connect the supplied hose to a water tap.
Caution! Do not start the product if the tap is
close, operation without water can cause damage to the
product.
1
Connect the suction hose of the product to a
water outlet.
2
Open the water tap.
3
Push the lock button and then the power trigger.
Note! It is not necessary to keep the lock button pushed.
4
Release the power trigger to stop the jet and stop
the product.
4.3.2 Operation with a suction hose
Caution! Make sure the filter is connected,
unwanted material in the water can cause damage the
high-pressure pump and accessories.
Caution! Do not start the product if the there is not
enough water in the container, operation without water
can cause damage to the product.
The can be used with a suction hose to suck water from a
barrel, or a pond.
1
Make sure that there is enough water in the
container.
2
Attach the suction hose to the product and put the
end of the hose with the filter basket in the water
container.
3
Push the lock button and then the power trigger.
Note! It is not necessary to keep the lock button pushed.
4
Release the power trigger to stop the jet and stop
the product.
Note! Make sure that the suction hose and the filter is
under the water to prevent air in the hose.
4.3.3 To connect the detergent container
Caution! Only use detergents applicable for
high-pressure washers.
1
Fill the container with detergent.
2
Attach the detergent container to the product.
Figure 2
3
Push the lock button and then the power trigger.
Note! It is not necessary to keep the lock button pushed.
4
Release the power trigger to stop the jet and stop
the product.
5
Clean the product after use. Refer to "6.1 To clean
the product" on page 8.
4.4 To adjust the spray head
The spray head has a nozzle with six different settings.
● Turn the nozzle holder to change the setting of the
nozzle.
● An arrow on the top of the spray head indicates the
selected setting. (Figure 3)
A.
Upward jet
B.
Jet angle 0°, 15°, 25°,40°
C.
Soft, wide jet for watering/cleaning
5
Transport
● Stop and remove the battery before you transport the
product.
6
Storage
Caution! Make sure that the product is clean and
dry before you put it in storage.
● Stop the product and remove the battery if the product
is not going to be used for a long period of time.
● If the product is not going to be used for a long period
of time, keep the product in a clean and dry area,
where children and pets do not have access to it.
EN
SV
NO
PL
DE
FI
FR
NL
7
Publicité
