Publicité
If you have problems with your cleaner, follow the troubleshooting below to restore performance. NOTE: Turn off
the power prior to making any repairs.
Problem
The switch knob cannot be
turned or cannot be
Turned easily
The robot does not power
on and therefore does not
operate
The indicator light flashes
red and the robot will not
operate
Trouble Shooting
Possible Causes
There is sand or other debris
stuck in the knob gap
The battery is damaged
The PCB board is damaged
The sealed box leaks
The robot is not
placed in the water in time, and
the pump protection feature
was
activated.
The impeller is damaged
The impeller may be stuck
due to debris
The motor is damaged
Motor overheating protection
The battery may need to be
charged
14
Solution
a.
Check whether sand or other
debris is stuck in the knob gap
b.
Remove sand or other debris
Go to
www.inopool-us.com
Support section and follow the
instructions for additional help
Go to
www.inopool-us.com
Support section and follow the
instructions for additional help
Go to
www.inopool-us.com
Support section and follow the
instructions for additional help
Restart the robot and submerge it
in water within 5-10 seconds
Replace the impeller avoiding its
sharp edges
Check the impeller and remove
the debris carefully
Go to
www.inopool-us.com
Support section and follow the
instructions for additional help
Wait 10 minutes and restart
the cleaner. Go to
www.inopool-us.com
if the
issue is not resolved
Charge the battery
Publicité
