Husqvarna Soff-Cut 2000 Manuel D'utilisation page 15

6. Push the forward speed lever in the direction of
"FAST" to move the product forward. Start slow and
increase the speed until you get the correct cutting
speed.
Note
Do not push the product.
a) Adjust the speed to the hardness of the concrete
to cut straight. Push or pull the forward speed
lever to adapt the speed.
793 - 001 - 19.04.2022
b) If the speed is too fast, the product turns right.
Decrease the speed to cut straight.
c) If the speed is too slow, the product turns left.
Increase the speed to cut straight.
7. Put your hands on the handlebar when you have the
correct cutting speed.
8. Pull the front pointer lever when you get near a wall
to lift the front pointer. Use the kerf guide to make
sure that you cut straight.
CAUTION
objects hit the blade block. It can cause
damage to the product.
Make sure that no
15