Prior To Operation - Hitachi D 10V1 Mode D'emploi Et Instructions De Securite

English

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms to the power source requirements
specified on the product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the plug is connected to a receptacle while
the switch is in the ON position, the power tool will start operating immediately and can
cause serious injury.
3. Extension cord
When the work area is far away from the power source, use an extension cord of sufficient
thickness and rated capacity. The extension cord should be kept as short as practicable.
WARNING:
4. Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired. Contact
a licensed electrician to make appropriate repairs.
If such a fautly receptacle is used, it may cause overheating, resulting in a serious hazard.
5. Confirming condition of the environment:
Confirm that the work site is placed under appropriate conditions conforming to
prescribed precautions.
6. Confirm the direction of bit rotation
The bit rotates clockwise (viewed from the rear side) by pushing the R-side of the
reversing switch lever.
The L-side of the lever is pushed to turn the bit counterclockwise.
CAUTION
Never change the direction of bit rotation while operating. Turn the power switch OFF
before changing the direction of bit rotation; otherwise, burning of the motor will result.
12
Damaged cord must be replaced or repaired.
Lever
〈D10V1, D10VC〉 〈D13V〉
Fig. 2
L side
Lever