Publicité
• Connectors:
• Power Sources – For UL security applications, when ext. power supply is used the product shall be
powered by a UL 294 or UL 603 listed Class 2 low-voltage power SELV and limited power supply with
appropriate ratings.
• External power to relays – If the relays are connected to an external power source this must be UL 294
listed Class 2 low-voltage power SELV and limited power supply.
• Network Connector – Standard Ethernet wiring. Evaluated by UL when powered from. The 2N product
was tested with the injector Axis 30 W MIDSPAN P/N: 02172-002. The midspan power injector can
be located at any point within the defined structured cabling channel compliant to the Standard for
Balanced Twisted-Pair Telecommunications Cabling and Components, ANSI/TIA-568-C.2, between the
network switch and the powered device (PD).
• System considerations:
• Monitoring software was not evaluated by UL, and is for supplemental use.
• Further information:
• Card formats verified by UL: ISO 14443A, ISO 14443B, ISO 15693, ISO 18092
• Firmware version:
• 2.x.x.x
• Power in:
• Ext. power source 12 V ± 1 V, max. 1 A DC
• Power over Ethernet (PoE) IEEE 802.3af (Class 0, max. 12.95 W)
• Power out:
• Active switch output 12 V DC, max. 600 mA
• I/O interface – I/O functionality:
• 2 Inputs:
• In active mode short-circuited = ON, open = OFF
• In passive mode external voltage in range of –30 V DC to +30 V DC may be applied, U
ON, U
> 1.5 = OFF
IN
• Relay:
• 1x form C relay, NO/NC, max. 1 A, max. 30 V AC/DC
• Installation cable requirements:
• Ext. power: AWG 20-16, qualified for up to 3 m (10 ft)
• Active switch output: AWG 20-16, qualified for up to 3 m (10 ft)
• Relay: AWG 20-16, qualified for up to 3 m (10 ft)
• Inputs: AWG 20-16, qualified for up to 3 m (10 ft)
• Ethernet and PoE: STP CAT 5e or higher, qualified for up to 100 m (328 ft)
Safety instructions
AVERTISSEMENT
The 2N product shall be installed by a trained professional, and in compliance with local
laws and regulations.
Instructions générales et mises en garde
51
< 1.5 V =
IN
Publicité
