Publicité
Bleeding the Accessory
Accessories should be bled of air any time an
accessory has been serviced, unused for a long
period of time or is connected to a hose that is not
pre-filled with oil. Please also consult accessory
manufacturer's recommendations for further bleed-
ing instructions.
If the hose and accessory retain
WARNING
pressure after the pump has re-
lieved pressure (either by using the Manual Pres-
sure Release Button or at the end of an opera-
tion), relieve pressure in a safe manner and re-
place the hose and remote pump couplers.
To bleed an accessory:
1. Remove the battery pack.
2. Connect the accessory hose to the coupler.
NOTE: The coupler must be pointed to the side, and
the tool must be positioned higher than the accessory
hose and head.
3. Insert the battery pack.
4. Press the hold pressure
5. Run the tool until the
cycle completes, and
the pressure indicator
lights green.
6. Press and hold the manual
release button for two sec-
onds, then release both
buttons.
7. Repeat steps 4-6 three to
four times.
NOTE: While bleeding the
accessory, make sure the oil
level does not drop below the
oil sight line. Refill the reservoir
if necessary.
button.
2
sec
Removing/Attaching the Remote Cord
To remove the remote cord, twist the cord grommet
loose and pull the cord away from the remote or tool.
To attach the remote cord, line up the keys of the
cord to the keys of the remote or tool. Push the cord
into the remote or tool and twist the cord grommet
until tight.
Selecting Mode
The pump features three modes of operation:
Auto-Dump mode
soon as 10,000 psi is reached.
Hold Pressure mode
manual pressure release button is pushed or the
retract button is pushed on the remote.
Wireless mode
pump via bluetooth signal. The pump will run to full
pressure and then release. The remote must be re-
attached for the next application. WARNING! Once
the pump is started using wireless mode, it will run
to completion and cannot be halted.
ONE-KEY™
To learn more about the ONE-KEY™ functionality
for this tool, go to milwaukeetool.com/One-Key. To
download the ONE-KEY™ app, visit the App Store
or Google Play™ from your smart device.
ONE-KEY™ Indicator
Solid Blue
Wireless mode is active and
ready to be configured via the
ONE-KEY™ app.
Blinking Blue Tool is actively communicating with
the ONE-KEY™ app.
Blinking Red Tool is in security lockout and can
be unlocked by the owner via the
ONE-KEY™ app.
6
unloads pump pressure as
holds pressure until the
allows the user to activate the
®
Publicité
