Publicité
INSTRUCTIONS FOR USE AND INSTALLATION
Congratulations on your choice!
You've chosen an appliance from the JIDÉ range, and we'd like to thank you for it. We are
convinced that it will bring you comfort and warmth.
In order to get the most out of your fireplace, we strongly emphasise the importance of
following the instructions and advice set out in this manual.
TABLE OF CONTENTS > for diagrams
INTRODUCTION
General information
Technical specifications and conformity
Spare parts - Rating plate
OPERATING INSTRUCTIONS
Ignition
Combustion
Combustion air
Convection air
The chimney
General recommendations
Wood - Choice and use
INSTALLATION INSTRUCTIONS
Preparation - Layout
Dimensions of the niche
Ventilation around the fireplace
Fireplace insulation
Fireplace seating
Fireplace radiation
Combustion air connection
Chimney connection
Placing the chimney connector
Fitting the finishing frame (optional)
Fitting and adjusting the baffles
FIREPLACE MAINTENANCE
Maintenance
Cleaning the ceramic glass
Door
Chimney sweeping
Life cycle
End of life cycle instructions
MALFUNCTIONS
CERTIFICATE OF CONFORMITY
PERFORMANCE CERTIFICATES
TECHNICAL DOCUMENTS
WARRANTY
3
3
4
5
8
8
8
8
9
9
10
10
14
14
14
14
14
14
15
15
15
16
17
18
19
19
19
20
21
21
21
22
24
25
29
Technical characteristics and compliance
Combining ecology and economy, JIDÉ has created the PURE range, which has two possible
combustion air intakes: an external combustion air intake (sealed appliance) (ideal situation)
or a combustion air intake directly into the room where it is installed.
The primary air is distributed under the fire bed via stainless steel ducts.
The secondary air creates an afterburner by re-burning the gases.
efficiency.
The preheated tertiary air has a 'turbo' effect, sweeping the glass from top to bottom to keep it
clean, and also contributes to combustion.
Ecological solution: Cleaner emissions, less dust and less CO.
Economical solution: significantly reduced wood consumption.
Translated with DeepL.com (free version)
JIDÉ submits its ranges of inserts to tests in accredited laboratories to ensure that they meet
the requirements of European EN standards in terms of safety and efficiency by limiting the
emission of CO and fine particles.
Test results according to standards
EN 13229:2001 - EN 13229/A1:2003 - EN 13229/A2:2004
Spare parts - Rating plate
In addition to the fireplace, the package contains the following items:
A poker - cold hand
A glove
A plug plate and fixing screws (to close the rear air intake if connecting from below).
Variable speed control
All JIDÉ fireplaces are listed as soon as they leave the factory, according to the information
on a nameplate on the back of the appliance. A duplicate is included with these instructions,
showing the appliance's power, efficiency and CO emissions.
This plate should be kept and, if necessary, will enable us to identify your appliance in our files
(traceability).
Translated with DeepL.com (free version)
37
Publicité
