Publicité
Recycling and disposal
3.6
Connecting the product to the heat generator
> Fig. 1.8 Plug the connection cable on the heat generator
into slot X32.
3.7
Connecting the relay to the product (optional)
> Fig. 1.6 If required, connect a relay to the product at slot
X14.
– Relay switch signal: Terminal F
– Low-voltage line relay: Terminal 24 V
18
All manuals and user guides at all-guides.com
3.8
> Start up the product.
> Set the target flow temperature to maximum.
> Check the installation of the interface.
Status
Lights up permanently
Flashing rapidlykend
Lights up with brief
interruptions
4
Disposing of the packaging
> Dispose of the packaging correctly.
> Observe all relevant regulations.
Completing installation
Meaning
No third-party control connected
Voltage: < 0,5V
No heat demand
No eBUS connection to the heat generator
Normal function
Voltage: > 1.5 V
Heat demand present
Recycling and disposal
Installation instructions VR34 0020287799_00
Publicité
