Publicité
▶
Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool
tether.
Installing or removing blower tube
Installing the blower tube
▶
Press and hold down the blower tube release button (1) and push the blower tube (2) into the
blower housing until it engages with an audible click.
Adjusting the blower tube
1. Turn the union nut (1) in the direction indicated by the
position.
2.Slide the head of blower tube (2) into position.
3. Turn the union nut (1) in the direction indicated by the
Removing the blower tube
▶
Press and hold down the blower tube release button and pull the blower tube off the blower
housing.
Operation
Switching on / off
1.Press the on/off button to switch the product on.
▶
The on/off button lights up and the product is in standby mode. To start the product working,
press the control switch or activate the continuous-running lock.
2.Press the on/off button again to switch the product off.
Activating continuous-running lock
1. Turn the continuous-running lock in the direction indicated by the
▶
The control switch is locked and the product runs in continuous-running mode.
2. Turn the continuous-running lock in the direction indicated by the
To deactivate the continuous-running lock, turn the continuous-running lock to its initial
position. The control switch can be unlocked.
Activating boost mode
The boost mode can be activated only while the product is running.
1.Press the boost mode button.
▶
The product runs in boost mode (see Technical data).
2.To return to the standard mode, press the boost mode button again.
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶
Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone
as these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
*2404437*
2
3
4
5
2404437
symbol to unlock the blower tube
symbol to lock the blower tube position.
symbol to increase speed.
symbol to reduce speed.
10
10
Publicité
