Publicité
Boost mode button
=
Grip
%
Battery
&
Blower housing
(
Control switch
)
Continuous-running lock
+
Eyelet for shoulder strap – front
§
Intended use
The product is a cordless blower for industrial and gardening use. It is intended for outdoor use,
clearing light concrete debris, light wood chips, leaves, grass and similar lightweight materials.
Information about compatible batteries and chargers
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum
performance, Hilti recommends the batteries stated in the table at the end of these operating
instructions for this product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
Items supplied
Cordless blower, blower tube, shoulder strap, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or
at: www.hilti.group
Status indicators of the Liion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of
health.
Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶
If the release button is pressed with a battery inserted in the product, subsequently check that the
battery is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following status indications is
applicable at the time.
State of charge and, if applicable, faults are indicated constantly as long as the connected product
is switched on.
Status
Four (4) LEDs show constantly green
Three (3) LEDs show constantly green
Two (2) LEDs show constantly green
One (1) LED shows constantly green
One (1) LED slow-flashes green
One (1) LED quick-flashes green
7
Blower tube
/
On/off button
:
Air intake for blower
∙
Eyelet for shoulder strap – rear
$
Battery release button
£
Battery status indicator
|
Meaning
State of charge: 100 % to 71 %
State of charge: 70 % to 51 %
State of charge: 50 % to 26 %
State of charge: 25 % to 10 %
State of charge: < 10 %
The Li-ion battery is completely discharged.
Recharge the battery.
If the LED again starts quick-flashing after the
battery has been charged, consult Hilti Service.
2404437
*2404437*
Publicité
