Publicité
Status
One (1) LED quick-flashes yellow
One (1) LED shows yellow
One (1) LED quick-flashes red
Indicators showing the battery's state of health
To check the battery's state of health, press the release button and hold it down for longer than
three seconds. The system does not detect a potential malfunction of the battery due to misuse, for
example battery dropped or pierced, external heat damage, etc.
Status
All LEDs show in sequence, followed by one (1)
LED showing constantly green.
All LEDs show in sequence, followed by one (1)
LED quick-flashing yellow.
All LEDs show in sequence, followed by one (1)
LED showing constantly red.
Technical data
Product information
Product generation
Rated voltage
Weight without battery
Air volumetric flow rate
Air speed (outlet)
Storage temperature
Ambient temperature for operation
*2404437*
Standard mode 388.5 CFM
Boost mode
Standard mode 44 m/s
Boost mode
2404437
Meaning
The Li-ion battery or the product in which it is
inserted is overloaded, too hot or too cold, or
experiencing some other fault.
Bring the product and the battery to the rec-
ommended working temperature and do not
overload the product when it is in use.
If the message persists, consult Hilti Service.
The Li-ion battery and the product in which it
is inserted are not compatible. Consult Hilti
Service.
The Li-ion battery is locked and cannot be
used. Consult Hilti Service.
Meaning
The battery can remain in use.
The check to ascertain the battery's state of
health did not complete. Repeat the procedure,
or consult Hilti Service.
If a connected product can still be used, the
remaining battery capacity is below 50 %.
If a connected product can no longer be used,
the battery has reached the end of its useful life
and has to be replaced. Consult Hilti Service.
01
21.6 V
3.15 kg
(6.94 lb)
459.1 CFM
(144 ft/s)
53 m/s
(174 ft/s)
−20 ℃ ... 70 ℃
(−4 ℉ ... 158 ℉)
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
8
Publicité
