Publicité
Decrease volume
Next track
Previous track
Fast forward
Rewind
Accept / end call
Reject call
Switch between two
callers
Activate voice assistant
Activate transparency
mode temporarily
Overview of the LED displays on the
headphone
Action
Low battery warning
Charging via USB 0 – 30 %
Charging via USB 31 – 70%
Charging via USB 71 – 99%
Charging via USB 100%
Switch on with battery
status 5 – 30 %
Switch on with battery
status 31 – 70 %
Switch on with battery
status 71 – 100 %
Bluetooth® pairing
recognisable
Bluetooth® connection
active
Bluetooth® connection
lost
Media playback active
Incoming call
Delete pairing list
Restore factory settings
AVENTHO 300 — Wireless Over-Ear Headphones
Swipe downwards on
�
the touch pad.
Swipe forwards on the
�
touch pad.
�
Swipe backwards on
the touch pad.
Swipe forwards on the
�
touch pad and hold for
at least 1 second.
Swipe backwards on
�
the touch pad and hold
for at least 1 second.
Briefly tap the touch
�
pad twice (
).
Tap and hold the touch
�
pad once (
).
�
Tap and hold the touch
pad once (
).
Tap and hold the touch
�
pad once (
).
Place the palm of your
�
hand on the right touch
pad.
LED display
LED flashes red rapidly
�
�
LED flashes red
LED flashes yellow
�
LED flashes green
�
LED illuminates green
�
LED lights up red once
�
�
LED lights up yellow
once
LED lights up green
�
once
LED flashes blue and
�
red
LED flashes blue
�
slowly with pauses
of 7 seconds
LED flashes blue
�
slowly with pauses
of 3 seconds
�
LED flashes slowly
blue with pauses
of 7 seconds
LED flashes rapidly blue
�
with pauses of 1 second
�
LED flashes yellow three
times
�
LED flashes yellow three
times
Audio cable connection
The delivery includes an audio cable with a mini jack
plug (3.5 mm) at both ends.
Connect one end of the
�
audio cable to the jack
socket of the headphone
housing, if you would like
to use the AVENTHO 300
without Bluetooth®.
�
Alternatively, you can use
the USB cable as an audio
cable.
Switch on the
�
AVENTHO 300. Please
note that with this type
of application power is
consumed via the battery.
Control the media playback
�
and volume via the playback device.
Cleaning
�
For reasons of hygiene, you should occasionally clean
the ear and headband pads with a soft cloth mois-
tened with water. Make sure that no water gets into
the ear cups or transducers.
Do not use cleaning agents containing solvents.
�
Never use a vacuum cleaner for cleaning the head-
�
phone, as this may cause irreparable damage.
As ear and headband pads are subject to natural
�
wear and tear, it will be necessary to replace them
from time to time. You can easily do this yourself.
If other components have to be replaced, please
�
contact your local beyerdynamic representative.
Changing the ear pads
Remove the ear pad from
�
the housing by grabbing
it at the lower end from
the inside under the ear
pad and pulling it
downwards from the
fastening ring of the
housing.
Attach the new ear pad
�
to the housing.
The five fastening noses
on the fastening ring
of the ear pad must be
inserted into the recesses
of the housing and click
into place.
9
Publicité
