Publicité
Multi-point operation
The AVENTHO 300 can be paired with up to eight devices
via Bluetooth®. An active connection is possible with a
maximum of two devices at the same time.
Music playback and phone operation is only possible
with one device at a time. Phone operation has priority
over music playback, i.e. music playback is interrupted
when a call is received.
The following priority list applies to the use of playback
devices (PD):
Priority
Profile
1
HFP (phone operation)
2
HFP (phone operation)
3
A2DP
(playback of music)
4
A2DP
(playback of music)
Setting up multi-point
�
Connect the AVENTHO 300 to the first device
(see "Pairing").
Deactivate the Bluetooth® connection on the first
�
device.
Switch off the AVENTHO 300.
�
Press the on/off button
�
7
the connection mode (status LED
alternately blue and red).
Connect the AVENTHO 300 to the second device
�
(see "Pairing").
Reactivate the Bluetooth® connection of the first
�
device, which automatically connects to the
AVENTHO 300.
When both devices are paired with the AVENTHO 300,
�
the AVENTHO 300 automatically connects to both
devices each time it is switched on.
Using multi-point
Media playback active /
accept call
Hang up / start media
playback again
Delete pairing list
Press and hold the on/off
�
button of the switched off
AVENTHO 300 for approx.
8 seconds, until the status
LED flashes yellow.
AVENTHO 300 — Wireless Over-Ear Headphones
Playback devices (PD)
PD 1 (device used first)
PD 2 (device used
second)
PD 1 (device used first)
PD 2 (device used
second)
for 6 seconds to start
flashes slowly
6
Briefly tap the touch pad
twice (
)
Briefly tap the touch pad
twice (
)
Switching the headphone on and off
Switching on
�
After you have paired
the AVENTHO 300 or use
it with a cable, press and
hold the on/off button
for approx. 2 seconds
(
).
The status LED lights up
once and then goes out.
It displays the respective
charge level.
Switching off
�
Press and hold the on/off button
for approx. 6 seconds (
If you are using the AVENTHO 300 with cable, you
must also switch it on to be able to use all available
functions.
Switch between noise cancellation (ANC)
and transparency mode
You can use the ANC button to switch between noise
cancellation (ANC), transparency mode and OFF mode.
The AVENTHO 300 is supplied in OFF mode.
If you press the ANC
�
button once each time,
the transparency mode,
the ANC mode and then
the OFF mode again is
activated one after the
other.
�
If you press the ANC
button twice each time,
the ANC mode, the
transparency mode and
then the OFF mode is
activated again.
You can make settings for noise cancellation (ANC)
and transparency mode in the beyerdynamic app.
If the transparency mode is only to be activated
temporarily when wearing the AVENTHO 300, place
the palm of your hand on the right side of the touch
pad.
6
).
Publicité
